Tighten all screws (U) in square frame (W). Attach upper frame (0) to each frame rod (5) using screw (R). Repeat for all 4 corners of square frame (W). MONTAGGIO DELL'APPARECCHIOĬonnect frame rod (S) to square frame (W) by lining up the foot (V) with the screw hole on square frame (W) and inserting screw (U) but do not tighten completely. Once the ideal position of the threaded post (F) is determined, tighten up the washer (D) and the hex nut (E) onto the threaded post (P) just beneath the mounting bracket (A) to secure the threaded post in place.
The threaded post (F) can be adjusted by loosening hex nut E) to allow movement of threaded post (F) on mounting bracket (A). Adjust the position of threaded po0st (F) on the mounting bracket (A) so that the canopy (H) covers at least half of the exterior threads on the canopy loop (G) while it is securely connected to threaded post (F). Determine this by lifting mounting bracket (A) up to the junction box and place canopy (H) over the canopy loop (G), so that it is tlush with the ceiling. Depending on the placement ot your junction box the position of threaded post (F) may need to be adjusted to allow the canopy to be flush with the ceiling.
Unscrew the canopy loop ring (0) from the canopy loop (G). The other end should have the canopy loop (G) attached. One end of the threaded post (F) should be attached to the mounting bracket (A) with a washer(D) and a hex nut (E) in place. Remove the new mounting bracket assembly from the bag. Shut of the power at the circuit breaker and completely remove the old fixture from the ceiling, including the old mounting bracket. Project aim – to create a prototype of an autonomous robotic system of used car parts recognitionįinancing from European Regional Development Fund – € 421,703.6.1 Manuali/risorse correlati Hunter Fan 19067 Laurel Ridge Pendant Light PREPARAZIONE PER L'INSTALLAZIONEĬarefully remove all contents from the carton.
Project title – Autonomous car spare parts identification system for intelligent promotion of auto parts reuse. Project is financed by the European Regional Development Fund. Successful implementation of the project will reduce labor costs, optimize car sales and increase the reuse of car parts. During the implementation of the project company plans to create an autonomous robotic system of identification of used car parts. JSC Ovoko is currently implementing the project “Autonomous car spare parts identification system for intelligent promotion of auto parts reuse”.
Implementation of the project “Autonomous car spare parts identification system for intelligent promotion of auto parts reuse”
0 kommentar(er)
